X-Net NAT Router Setup for MegaPass Broadband Wireless Connection

1. Follow the set up instructions on the NAT router manual - Getting started
2. Go to the web page at 192.168.2.1 and choose Quick Set Up
3. Change the time zone to Auckland/Wellington > Apply
4. Broadband type > Fixed-IP xDSL
   
   IP address assigned by ISP: ____. ____. ____. ____
   Subnet Mask: 255.255.255. ____
   DNS Address: 202.169.212.2
   Service Provider Gateway Address: ____. ____. ____. ____
   (Gateway ¡V same range as the given IP address, except last number is different)
   
   
5. Click OK
6. Click on the top right corner HOME > General Set Up
7. On the left hand panel, choose Nat > Enable UPnP > Apply> OK (normally disable for commercial use)
8. Choose Firewall > Enable > Apply
   
   Choose Firewall > Dos > tick: Ping of Death, Port Scan, Sync Flood
   Then click on Apply > Ok
   
   
9. Click on the top right corner HOME > General Set Up
10. You are recommended to change the admin password of your router.
    
    General Set Up > System > Password > type your old & new password > Apply. (write password below)
    
    
11. Choose LAN and if you need a different local IP range, then set the IP address:
    
    IP address ____. ____. ____. ____ (will become the gateway on all local computers).
    Set local computer IP addresses in the same range, eg ____. ____. ____. xxx
    Set the router's DHCP setting to be .100 to .200 > Apply > then update setting following step 13.
    
    
12. The router setting has been completed.
13. Follow the Computer Network Setting for your computers.

Computer Network Setting

For Windows 95/ 98/ 98SE/ ME

1. Go to Control Panel > Network
2. Double click on TCP/IP for your network card (Ethernet adapter)

For Windows NT/ 2000/ XP

1. Go to Control Panel > Network Connection
2. Right Click on Local Area Network, then select properties
3. Double click on Internet Protocol (TCP/IP)

For single PC only, without router

Use following IP setting provided by WorldNet in your computer that connects directly to MegaPass.

• IP address: Use the IP address provided (from Router Setting 4. above)
• Subnet mask: 255.255.255.xxx (from Router Setting 4. above)
• Default gateway: Gateway address provided (from Router Setting 4. above)
• Primary DNS server: 202.169.212.2
• Alternate DNS server: 202.169.206.10

For several PCs (connected with Broadband Router)

All networked computers can either set network IP addresses automatically need to restart, or use the following setting: (Note - for automatic setting, remember the router must be on and connected before starting computers)

• IP address:
  1st computer 192.168.2.2
  2nd computer 192.168.2.3
  3nd computer 192.168.2.4
  (or same local address range as the router in 9. above, eg ____ . ____ . ____ . xxx )
  
• Subnet mask: 255.255.255.0
• Default gateway: 192.168.2.1 (or the router's local IP address from Router Setting 9. above)